Extending a wall and got up into my attic to make sure I have a rafter to nail to and the rafter is 4 inches over from where I want to extend my new wall. Not sure what the existing wall header is nailed to. Should i just toenail some 2X4 up there to nail the top of my frame to?
I'm going to be installing prefinished 3in hardwoods and will be doing so in the great room and kitchen. I have a pneumatic nailer which will make the job easier but as I get near the cabinets, I won't be able to use my nailer and face nailing would prove challenging under the cabinet. I was thinking of pre-drilling holes and using a racheting nailer (like the one at Sears) to hammer it in before I could countersink it but wanted to hear if you have any advice. I'm open to suggestions. Thanks.
Is repair possible or replacement necessary for two inward bulging concrete block walls of an integral garage? They are also pushed in from their foundation approximately 3" of the 8" blocks? The bulge starts is half-way up, which is underground. Also, what would be the typical cost for both procedures?
I have just bought a house and it has a 20 x 30 worshop outback. It's a metal building on a concrete slab. They did a pretty good job putting it together but there are many gaps between the walls and the slab. Also, there are many places in the walls and roof where they missed their mark for the screws and so there many holes. My question is how do I seal this building? I want everything sealed! I live in Georgia so this summer I would like to run some AC out there without cooling the entire county. Thanks.
We are buying a house in Knightdale NC. My question pertains to waterproof sheetrock or wonderboard. We are having the house built and I have noticed during the drywall inspection that standard white sheetrock is beige used in the bathrooms. Should I request/demand waterproof sheetrock or wonderboard?
Our triple-car garage in Ogden, Utah, faces west. Even with ceiling and wall insulation it gets really hot in the summer and really cold in the winter. We'd be happy with around 83 degrees in the summer and 50 degrees in the winter. Would it be more cost-effective to install through-the-wall heating and cooling units or to purchase insulated garage doors?
I am considering replacing a garage door by myself. Is this a realistic do-it-yourself project? What is involved, or should I look for a contractor. The garage is attached to two story house. Original door sinice l969.
I have extensive wood dry rot affecting the entire wall behind the master bath shower. Some of the dry rot affects structural beams and the framing supporting 2 windows. What type of contractor is best suited to repair this? Is a general contractor trained to peform such repair?
I live in Cleveland, Ohio, and would like build a two-car garage with a small apartment above it behind my house (there's already a driveway in place) for my mother to live in. I'm imagining a garage of about 22' x 20' with approximately 400 sq. feet of living space on top. My partner and I had a well-regarded garage contractor (Angie's List) give us a guesstimate of $80,000. Another contractor would not give us an estimate, but insisted we needed an architect in addition for the apartment design and suggested we ask him how much it would cost. Doing casual internet searches I've found that $80,000 is on the high end of normal. Without going too cheap or cutting corners, what is your estimate for the least we can spend to build?
I have a cathedral ceiling in which I would like to install a skylight. There are skylights on the other side of the roof, but they are boxed in so the light comes to standard ceiling height. What's involved in this type of project?